Electric 5k-6k Draw Bar Pull Burden Carrier Tractor

This is a Request for Information (RFI) synopsis only, not a solicitation announcement and is issued solely for informational and planning purposes. This posting is not a Request for Proposals (RFP) or a Request for Quotes (RFQ) and it is not considered to be a commitment by the Government to award a contract nor is the Government responsible for any costs incurred in furnishing information provided under this RFI synopsis. No basis for claim against the Government shall arise as a result of a response to this RFI synopsis or Government use of any information provided. Further, the Government is not at this time seeking proposals or quotes and will not accept unsolicited proposals or quotes. No proprietary, classified, confidential, or sensitive information should be included in your response to this RFI synopsis. The Government reserves the right to use any information provided by respondents for any purpose deemed necessary and legally appropriate, including using technical information provided by respondents in any resultant solicitation. Responses will assist the Government in determining the availability of potential solutions and commercial products in the market. At this time, no solicitation exists; therefore, do not request a copy of the solicitation. It is the responsibility of the potential offerors to monitor this site for additional information pertaining to this requirement. The United States Coast Guard (USCG) Aviation Logistics Center (ALC) is conducting market research to seek sources that can provide or manufacture an  Electric 5k–6k draw bar pull ( DBP) Burden Carrier Tractor  that meets the requirements as outlined in the below specifications: Specifications Electric 5k - 6k DBP Burden Carrier Tractor Section 1- Scope: Conventional Burden Carrier Tractor of 5K - 6K draw bar pull (DBP) OR 50,000 pounds force minimum, to 70,000 pounds force maximum. Section 2 – Delivery Requirements: First Article Unit, Quantity one (1) to be delivered 120-160 days after receipt of order (ARO).   Estimated quantity of production units is one hundred and sixteen (116). Section 3 – Requirements: Length without hitches not longer than 120 inches maximum. Length with hitches not longer than 150 inches maximum. Overall height is not taller than 90 inches maximum, with cab and beacon. Overall width is 80 inches maximum without mirrors. Tow Tractor gross weight: minimum 7,000 lbs. to 10,000lbs. maximum. Draw Bar Pull Force (DBF): minimum 5,000 lbs. to 6,000 lbs. maximum Rated capacity both front and rear. Performance: Minimum continuous increase forward speed. Minimum one speed reverse. Reverse (R), Neutral (N), Forward (F), or Reverse (R), Neutral (N), D1 (low range), D2 (high range). Travel speed - The tractor, without load, shall be capable of attaining and maintaining a travel speed on level, paved roads of not less than 15 mph forward. Two- or four-wheel drive. Hydrostatic steering. Power steering, with emergency steering in the event of power failure, shall be furnished. Suspension: Front: leaf spring or coil spring. Rear: leaf springs. Hydraulic service braking circuit: The service braking system shall be the commercially available system provided by the manufacturer. The service brakes shall be capable of bringing the tractor to a complete safe stop in accordance ASME B30.5. Not more than 80 pounds of force on the brake pedal shall be required to meet the requirements of ASME B30.5. Parking brake: Parking brake(s) shall hold, but not necessarily stop the tractor, without rated load when the tractor is stopped on a 15 percent grade in both the ascending and descending position. The parking brakes shall be operated by hand or foot controls and is located within reach of the seated operator. The brake shall have a locking device. The force required to pull the hand lever when setting the brake shall not exceed 35 pounds. The parking brake shall be independent from the service brakes. Front and rear inching controls: Inching movement: 3 inches minimum when activated within 5 seconds. Power source: Powered by an electric Lithium-Ion battery. Minimum capacity of 10kW or higher. On board charging system, 208-240V and/or 440-480V input voltage, three phase, 60Hz. Optional external charging system, 208-240V and/or 440-480V input voltage, three phase, 60Hz. First article will be 208-240VAC. An alternate 440-480VAC version will be required. If first article passes testing, an alternate 440-480VAC is required for other locations, unless the charger configuration is capable to accept 208-480VAC. Towing hitch: Minimum 2-level front and rear hitches. 1.18inch minimum to 2.75inch pin diameter maximum. Operators cab with doors, windows, and mirrors: Operator and passenger cab. The tractor shall be equipped with an enclosed cab and shall have doors with at least one window in each, which can be opened for ventilation. The doors shall be provided with hinges that can be serviced without door